Siemens SINUMERIK 840D Diagnostics Manual page 447

10.04
61332
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61336
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61338
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61339
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 block %2 change tool tip position
%1 = Channel number
%2 = Block number, label
The tool tip is below the measuring probe surface (e.g. for a ring gauge or cube).
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Place the tool above the measuring probe surface.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Geometry axes do not exist
%1 = Channel number
%2 = Block number, label channel number
No geometry axes configured
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Machine data in MD 20060 must be changed.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 positioning velocity is zero
%1 = Channel number
%2 = Block number, label
For some measuring versions, e.g. measuring spigots, in addition to the actual measuring
paths, intermediate paths were generated that are traversed with a specified feed.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Set the appropriate feed (plane feed/infeed) via MD 9757 or 9758.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Correction factor for rapid traverse speed < 0
%1 = Channel number
%2 = Block number, label channel number
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check parameter _SPEED[0] in GUD6.
Clear alarm with the RESET key. Restart part program
1 Alarms
1-447