Siemens SINUMERIK 840D Diagnostics Manual page 83

10.04
Remedy:
Program Continuation:
8020
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
8021
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
8022
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
8023
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Please inform the authorized personnel/service department. The sum of all axes that
have been configured through the channel-specific MD 20070
AXCONF_MACHAX_USED, must not exceed the maximum number of axes (dependent
on configuration -> option, basic version: 4 axes).
Switch control OFF - ON.
Option 'activation of more than %1 channels' not set
%1 = Number of channels
A 2nd channel has been indicated but the corresponding option does not exist.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
In the system-specific MD 10010 ASSIGN_CHAN_TO_MODE_GROUP, reduce the num-
ber of channels to 1 or retrofit the option for a 2nd channel.
Switch control OFF - ON.
Option 'activation of more than %1 mode groups' not set
%1 = Number of mode groups
The option for the number of mode groups is not compatible with the activated mode
group.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Add option for more mode groups. Activate fewer mode groups.
Switch control OFF - ON.
Option 'activation of more than %1KB SRAM' not set
%1 = Memory size
The option for memory extension does not correspond to the active SRAM.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Please inform the authorized personnel/service department.
• Buy option
• Activate less SRAM
Switch control OFF - ON.
Option 'Activation of more than %1 KB PLC user memory' not set
%1 = Memory size
The option for the memory configuration does not correspond to the PLC user memory
used.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Please inform the authorized personnel/service department.
• Purchase option
• Use less PLC user memory
Switch control OFF - ON.
1 Alarms
1-83