Siemens SINUMERIK 840D Diagnostics Manual page 504

1 Alarms
105012
Definitions:
Remedy:
Program Continuation:
105013
Definitions:
Remedy:
Program Continuation:
105014
Definitions:
Remedy:
Program Continuation:
105015
Definitions:
Remedy:
Program Continuation:
105016
Definitions:
Remedy:
Program Continuation:
105017
Definitions:
Remedy:
Program Continuation:
105018
Definitions:
Remedy:
Program Continuation:
105019
Definitions:
Remedy:
Program Continuation:
105020
Definitions:
Remedy:
Program Continuation:
1-504
The program is not or only partially editable (NC reset)
The selected program is currently being executed.
--
Internal
The copied data can be inserted with the softkey 'Paste'
The copied data is in the clipboard and can be inserted anywhere via the softkey "Paste".
--
Internal
Error while copying!
The file could not be copied.
--
Internal
Error while renaming!
The file could not be renamed.
--
Internal
Error while deleting!
The file could not be deleted.
--
Internal
Selection is only possible after being enabled or in the RESET state.
The selected program is either being currently executed or was not yet enabled.
--
Internal
Error during program generation!
The program could not be created; there may no longer be sufficient memory.
--
Internal
Error while opening a window!
The window could not be opened.
System error that should not occur in normal operation.
--
Internal
Error while closing a window!
The window could not be closed.
System error that should not occur in normal operation.
--
Internal
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04