Siemens SINUMERIK 840D Diagnostics Manual page 469

10.04
62183
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
62184
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
62185
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
62186
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
62187
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
62200
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 block %2 retraction mode GUD7 _TC_FR beyond value range 0...2
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE800.
- Alarm display.
-
Clear alarm with the Delete key or NC START.
Channel %1 block %2 no solution possible with current input angle values
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE800.
- Alarm display.
-
Clear alarm with the Delete key or NC START.
Channel %1 block %2 no end stop assigned to rotary axes
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE800.
- Alarm display.
Check installation and start-up of the swivel cycle CYCLE800.
Clear alarm with the Delete key or NC START.
Channel %1 block %2 illegal rotary axis vectors
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE800.
- Alarm display.
Check installation and start-up of the swivel cycle CYCLE800.
Clear alarm with the Delete key or NC START.
Channel %1 block %2 name of swivel data block unknown
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE800.
- Alarm display.
-
Clear alarm with the Delete key or NC START.
Channel %1 block %2: Start spindle
-
- Alarm display.
Start the tool spindle before machining the thread.
Clear alarm with the RESET key. Restart part program
1 Alarms
1-469