Siemens SINUMERIK 840D Diagnostics Manual page 137

10.04
Remedy:
Program Continuation:
10961
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10962
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10980
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
12000
Parameters:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 maximum cubic polynomials are allowed on active radius
compensation.
%1 = Channel number
%2 = Block number, label
With active radius compensation, only up to cubic polynomials are permissible for the
geometry axes. In this case no 4th or 5th degree polynomials can be programmed.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 function %3 not possible with path correction
%1 = Channel number
%2 = Block number, label
%3 = Function name
With this software release, the specified function can not yet be used together with tool
radius compensation. Please modify the part program or obtain a higher software version.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 orientation smoothing not possible
%1 = Channel number
%2 = Block number, label
In the case of active path-relative orientation interpolation with ORIPATH, orientation
smoothing cannot be activated. This means that in the 34th modal G code group
G code OSOF must be active.
- Correction block is reorganized.
- Interpreter stop
- Interface signals are set.
- Alarm display.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 address %3 programmed repeatedly
%1 = Channel number
%2 = Block number, label
%3 = Source string of the address
1 Alarms
1-137