Siemens SINUMERIK 840D Diagnostics Manual page 463

10.04
Reactions:
Remedy:
Program Continuation:
61613
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61800
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61801
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61802
Parameters:
Definitions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
--
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 undercut position incorrectly defined
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycles: CYCLE94, CYCLE96.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Check value in parameter _VARI.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: External CNC system missing
%1 = Channel number
%2 = Block number, label
Machine data for external language MD18800: $MN_MM_EXTERN_LANGUAGE or
option bit 19800 $ON_EXTERN_LANGUAGE is not set.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Internal
Channel %1 block %2: Wrong G code selected
%1 = Channel number
%2 = Block number, label
In the program call CYCLE300<value> an impermissible numerical value was pro-
grammed for the entered CNC_System, or in the Cycles_Setting_Datum an incorrect
value for the G_Code_System was set.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Internal
Channel %1 block %2: Wrong axis type
%1 = Channel number
%2 = Block number, label
The programmed axis is assigned to a spindle
1 Alarms
1-463