Siemens SINUMERIK 840D Diagnostics Manual page 417

10.04
61002
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61003
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61004
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61005
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61006
Parameters:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 block %2 machining type wrongly defined
%1 = Channel number
%2 = Block number, label
The value of the VARI parameter for the machining has been incorrectly specified. Alarm
triggered by following cycles: SLOT1, SLOT2, POCKET1 to POCKET4, CYCLE71,
CYCLE72, CYCLE76, CYCLE77, CYCLE93, CYCLE95, CYCLE97, CYCLE98.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Modify VARI parameter.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 no feed programmed in the cycle
%1 = Channel number
%2 = Block number, label
The parameter for the feed has been incorrectly specified. Alarm triggered by following
cycles: CYCLE71, CYCLE72.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Modify feed parameter.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 configuration geometry axis incorrect
%1 = Channel number
%2 = Block number, label
The geometry-axes sequence is wrong. CYCLE328
- Alarm display.
--
Internal
Channel %1 block %2 3rd geometry axis not present
%1 = Channel number
%2 = Block number, label
With an application on the lathe with no Y-axis in the G18 plane. Alarm triggered by fol-
lowing cycle: CYCLE86.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
--
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 tool radius too large
%1 = Channel number
%2 = Block number, label
1 Alarms
1-417