Siemens SINUMERIK 840D Diagnostics Manual page 250

1 Alarms
Reactions:
Remedy:
Program Continuation:
16111
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16112
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16120
Parameters:
Definitions:
1-250
Speed control (M41 - M45 or M40 and S...)
Control mode:
Speed control (spindle speed under S..., M3/M4/M5)
Position control (SPCON/SPCOF, spindle speed under S..., M3/M4/M5)
Axis mode:
Position control (M70/M3, M4, M5, axis position under user-selectable axis name)
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Check part program for correct spindle number.
With M3, M4 or M5 put the required spindle into control mode before calling the dwell
time.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 spindle %3 No speed programmed
%1 = Channel number
%2 = Block number, label
%3 = Spindle
Programming of a speed is expected.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Program speed with S[spindle number]=..
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 following spindle %3 Impermissible programming
%1 = Channel number
%2 = Block number, label
%3 = Spindle
With synchronous spindle-VV-coupling an additional motion for the following spindle can
only be programmed with M3, M4, M5 and S... The paths created by specified positions
cannot be maintained safely for a velocity coupling, especially if a position control is miss-
ing. If dimensional accuracy or reproducibility are not important, the alarm can be sup-
pressed with machine data 11410 SUPPRESS_ALARM_MASK Bit27 = 1.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Use synchronous spindle-DV-coupling or program direction of rotation and speed.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 invalid index for tool fine compensation
%1 = Channel number
%2 = Block number, label
Mistake in programming: The 2nd parameter in the PUTFTOC command indicates for
which tool parameter the value is to be corrected (1 - 3 tool lengths, 4 tool radius). The
programmed value is beyond the permitted range.
Permissible values are 1 - 4 if on-line tool radius compensation is allowed (see machine
data ONLINE_CUTCOM_ENABLE), otherwise values 1 - 3.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04