Siemens SINUMERIK 840D Diagnostics Manual page 425

10.04
61121
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61122
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61124
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61125
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 block %2 number of teeth per cutting edge missing
%1 = Channel number
%2 = Block number, label
No value was entered for the number of teeth per cutting edge. Alarm triggered by follow-
ing cycles: CYCLE70.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Enter the number of teeth/cutting edges for the active tool into the tool list.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 safety clearance on the plane incorrectly defined
%1 = Channel number
%2 = Block number, label
The safety clearance is negative or zero. This is not allowed.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Define the safety clearance.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 infeed width is not programmed
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE71.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
With active simulation without tool, a value for the infeed width _MIDA must always be
programmed.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 technology selection in parameter _TECHNO incorrectly
defined
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycles: CYCLE84, CYCLE840.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Check parameter _TECHNO.
Clear alarm with the RESET key. Restart part program
1 Alarms
1-425