Siemens SINUMERIK 840D Diagnostics Manual page 468

1 Alarms
Remedy:
Program Continuation:
62103
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
62105
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
62180
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
62181
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
62182
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-468
Check whether the spindle rotates.
Clear alarm with the Delete key or NC START.
Channel %1 block %2: The finishing allowance is not programmed
%1 = Channel number
%2 = Block number, label
No finishing allowance is programmed, although it is necessary for this machining.
- Alarm display.
Programm a finishing allowance.
Clear alarm with the Delete key or NC START.
Channel %1 block %2 number of columns or lines is zero
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE801.
- Alarm display.
-
Clear alarm with the Delete key or NC START.
Channel %1 block %2 no name assigned to swivel data block although machine
data $MN_MM_NUM_TOOL_CARRIER > 1
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE800.
- Alarm display.
-
Clear alarm with the Delete key or NC START.
Channel %1 block %2 NCK software version insufficient (missing TOOLCARRIER
functionality)
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE800.
- Alarm display.
--
Clear alarm with the Delete key or NC START.
Channel %1 block %2: Load swivel head
%1 = Channel number
%2 = Block number, label
No swivel head is active. Alarm triggered by following cycles: E_TCARR, F_TCARR.
- Alarm display.
Request to load a swivel head.
Clear alarm with the Delete key or NC START.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04