Siemens SINUMERIK 840D Diagnostics Manual page 296

1 Alarms
Remedy:
Program Continuation:
17220
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17224
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17230
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-296
Make sure that the manual tools are exchanged. The alarm is cleared automatically after
PLC acknowledgement of the tool change on command. Manual tools can only be used
efficiently if this is supported by the PLC program.
Alarm display showing cause of alarm disappears. No further operator action necessary.
Channel %1 block %2 tool not existing
%1 = Channel number
%2 = Block number, label
If an attempt is made to access a tool that has not or not yet been defined, via T no., tool
name, or tool name and duplo number, e.g. if tools shall be positioned in magazine loca-
tions via programming of $TC_MPP6 = 'toolNo'. It will only be possible, if both the maga-
zine location and the tool determined by 'toolNo' have been defined.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Correct the NC program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 tool T/D= %3 - tool type %4 is not permitted
%1 = Channel number
%2 = Block number, label
%3 = Incorrect T no. / D no.
%4 = Incorrect tool type
On this system, it is not possible to select tool offsets of the indicated tool types.
The variety of tool types can both be limited by the machine OEM
and be reduced on individual control models.
Only use tools of the tool types permitted for this system.
Check whether an error has occurred on defining the tool.
- Correction block is reorganized.
- Interpreter stop
- Interface signals are set.
- Alarm display.
Correct the NC program or correct the tool data
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 Duplo no. already assigned
%1 = Channel number
%2 = Block number, label
If an attempt is made to write a tool Duplo number to the name of which another tool
(another T number) already exists with the same Duplo number.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Correct the NC program.
Clear alarm with NC START or RESET key and continue the program.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04