Siemens SINUMERIK 840D Diagnostics Manual page 199

10.04
Remedy:
Program Continuation:
14159
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14160
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14165
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14170
Parameters:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Modify program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 more than two angles programmed with ROTS or AROTS
%1 = Channel number
%2 = Block number, label
Frame rotations are described using space angles with the language commands ROTS or
AROTS. A maximum of two angles can be programmed.
- Correction block is reorganized.
- Interpreter stop
- Interface signals are set.
- Alarm display.
Modify program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 tool length selection without geometry axis specification
%1 = Channel number
%2 = Block number, label
If variant C (tool length acts on the programmed axis) is activated by machine data
$MC_TOOL_CORR_MODE for tool length compensation with H word and G43/G44 in
ISO_2 mode, at least one geometry axis must be specified.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Change machine data $MC_TOOL_CORR_MODE or the part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 selected H number %3 does not match tool %4
%1 = Channel number
%2 = Block number, label
%3 = H/D number of ISO mode
%4 = Tool number
When an H or D number is programmed in ISO_2 mode, it must be available in the active
tool. The active tool may also be the last loaded tool on the master spindle or master tool-
holder. If there is no H or D number on this tool, this alarm will be output.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Set H number correctly.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal interpolation type with tool length compensation
%1 = Channel number
%2 = Block number, label
1 Alarms
1-199