Siemens SINUMERIK 840D Diagnostics Manual page 89

10.04
Program Continuation:
10204
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10205
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10206
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10207
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10208
Parameters:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel-specific reference point approach: The rising edge of the interface signal "acti-
vate referencing" (DB 21 - 28, DBX 1.0) starts an automatic sequence which starts the
axes of the channel in the same sequence as specified in the axis-specific MD 34110
REFP_CYCLE_NR (axis sequence channel-specific referencing). 0: The axis does not
participate in channel-specific referencing, but it must be referenced for NC Start, -1: The
axis does not participate in channel-specific referencing, but it need not be referenced for
NC Start, 1- 8: Starting sequence for the channel-specific referencing (simultaneous start
at the same no.), 1 - 31: CPU type
Axis-specific referencing: Press the direction key that corresponds to the approach direc-
tion in the axis-specific MD 34010 REFP_CAM_MDIR_IS_MINUS (reference point
approach in minus direction).
Clear alarm with NC START or RESET key and continue the program.
[up to SW 3.x only] Channel %1 general error
%1 = Channel number
A general error has occurred in the channel.
- Alarm display.
This message indicates an internal conflict with no further consequences.
Clear alarm with the Delete key or NC START.
[up to SW 3.x only] Channel %1 internal error in %2
%1 = Channel number
%2 = String
An internal error has occurred in the channel.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Press RESET.
Clear alarm with the RESET key. Restart part program.
[up to SW 3.x only] Channel %1 general error in function generator
%1 = Channel number
An error has occurred during activation/deactivation of the function generator.
- Alarm display.
Press RESET.
Clear alarm with the Delete key or NC START.
Channel %1 error when selecting or deselecting the digitize function
%1 = Channel number
An error has occurred on activating/deactivating the digitizing module; e.g. not in channel
ready state, already activated, etc.
- Alarm display.
Press RESET.
Clear alarm with the Delete key or NC START.
Channel %1 continue program with NC start
%1 = Channel number
1 Alarms
1-89