Siemens SINUMERIK 840D Diagnostics Manual page 116

1 Alarms
Reactions:
Remedy:
Program Continuation:
10765
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10766
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10767
Parameters:
Definitions:
Reactions:
1-116
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 3D tool radius compensation not possible
%1 = Channel number
%2 = Block number, label
This alarm occurs when an attempt is made to activate the 3D tool radius compensation
even though the option required for this is not fitted in the control.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Use another software version. The option cannot be activated by altering machine data
because the necessary code is not physically available.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 illegal change of surface orientation between block %2 and block %3
%1 = Channel number
%2 = Block number, label
%3 = Block number, label
This alarm occurs with 3D face milling when, at the time of block transition, the surface
defined in the first block is continued in the second block with the rear side of the surface
defined there. The block number in the alarm designates the second block.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 processing with tilt angle unequal 0 not possible
%1 = Channel number
%2 = Block number, label
When face milling with a torus milling cutter, the tilt angle must be 0 if the surface normal
vector and the tool orientation include an angle that is less than the limiting angle given by
the machine data 21082 CUTCOM_PLANE_ORI_LIMIT, i.e. in this case only the lead
angle may be unequal to 0.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04