Siemens SINUMERIK 840D Diagnostics Manual page 252

1 Alarms
Definitions:
Reactions:
Remedy:
Program Continuation:
16300
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16400
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16410
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-252
The spline and polynomial interpolation are options that are not contained in the basic
version of the control.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Do not program spline and polynomial interpolation, or retrofit the necessary option.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 denominator polynominal with zero places within parameter
range not allowed
%1 = Channel number
%2 = Block number, label
The programmed denominator polynomial (with PL [ ] = ... , i.e. without specification of
geometry axis) has a zero place within the defined parameter range (PL = ...). This means
that the quotient of the numerator polynomial and the denominator polynomial is infinite or
indeterminate.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify the polynomial block so that there is no zero place within the polynomial length in
the denominator polynomial.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 positioning axis %3 cannot participate in spline
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
An axis assigned to a spline grouping (n) with SPLINEPATH (n, AX1, AX2, ...) has been
programmed as positioning axis with POS or POSA.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Do not assign the positioning axis to the spline grouping.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 axis %3 is not a geometry axis
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
A geometry axis has been programmed that cannot be imaged on any machine axis in the
current transformation (possibly there is no transformation active at the moment).
Example:
Without transformation: Polar coordinate system with X, Z, and C axis
With transformation: Cartesian coordinate system with X, Y, and Z, e.g. with TRANSMIT.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Activate transformation type with TRAORI (n) or do not program geometry axes that do
not participate in the transformation grouping.
Clear alarm with NC START or RESET key and continue the program.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04