Siemens SINUMERIK 840D Diagnostics Manual page 347

10.04
22040
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
22045
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
22050
Parameters:
Definitions:
Reactions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 block %3 spindle %2 is not referenced with zero marker
%1 = Channel number
%2 = Axis name, spindle number
%3 = Block number, label
The current position is not referenced with the MS position although reference is made to
it.
- Alarm display.
Correct NC part program. Create the zero mark synchronization by positioning, by rota-
tion (at least 1 revolution) in speed control mode or G74 before switching the alarm gener-
ating function on.
Clear alarm with the Delete key or NC START.
Block %2 spindle/axis %3 not available in channel %1 because active in channel %4
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Number of the channel in which the spindle/axis is currently active.
The specified spindle/axis is required in channel %1 for the correct execution of a func-
tion. The spindle/axis is currently active in the %4 channel. The constellation can only
occur with replacement axes.
Problem case: A synchronized spindle coupling was programmed. The master spindle/
axis is not contained in the channel programmed for the coupling at the time the coupling
is activated. The master spindle/axis can be moved by FC18 or synchronized actions.
When using FC18, please note that the master spindle/axis must be assigned to the
channel which activates the coupling. When FC18 terminates, the master spindle/axis
must not be assigned to another channel via PLC while the coupling is still active (VDI
interface signals).
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
• Program a GET for the master spindle/axis in the NC program before activating the cou-
pling, or
• Assign the master spindle/axis to the channel that activated the coupling via PLC.
Clear alarm with the Delete key or NC START.
Channel %1 block %3 spindle %2 no transition from speed control mode to position
control mode
%1 = Channel number
%2 = Axis name, spindle number
%3 = Block number, label
• An oriented spindle stop (SPOS/SPOSA) has been programmed or the position control
of the spindle was switched on with SPCON but no spindle encoder has been defined.
• When switching on the position control, the spindle speed is greater than the limiting
speed of the measuring system.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
1 Alarms
1-347