Siemens SINUMERIK 840D Diagnostics Manual page 173

10.04
Remedy:
Program Continuation:
14001
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14005
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14009
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14010
Parameters:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
End part program with M30, M02 or M17 and start part program. Check environment vari-
ables NCPROG and NCUPROG at the host.
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 illegal end of block
%1 = Channel number
%2 = Block number, label
After system-internal data manipulation (e.g. when transferring blocks from an external
source) a subfile can end without having LF as the last character.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Read out the part program, modify it with a text editor (e.g., insert blanks or comments
before the displayed block), so that after reading it in again the part program has a differ-
ent structure in the memory.
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 program %3 program-specific start disable has been set
%1 = Channel number
%2 = Block number, label
%3 = Program name
Program %3 cannot be executed, as the program-specific start disable has been set for
this file.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Reset the program-specific start disable for file %3.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal program path %3
%1 = Channel number
%2 = Block number, label
%3 = Program path
The part program command CALLPATH was called with a parameter (program path)
referring to a directory which does not exist in the file system of the NCK.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
• Modify the CALLPATH instruction such that the parameter contains the complete path
name of the loaded directory.
• Load the programmed directory in the file system of the NCK.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 invalid default parameter in subroutine call
%1 = Channel number
%2 = Block number, label
1 Alarms
1-173