Siemens SINUMERIK 840D Diagnostics Manual page 424

1 Alarms
61117
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61118
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61119
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61120
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-424
Channel %1 block %2 active tool radius <= 0
%1 = Channel number
%2 = Block number, label
The radius of the active tool is negative or zero. Alarm triggered by following cycles:
CYCLE71, POCKET3, POCKET4.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Modify radius.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 length or width = 0
%1 = Channel number
%2 = Block number, label
The length or width of the milling area is illegal. Alarm triggered by following cycle:
CYCLE71.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Check parameters _LENG and _WID.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 nominal or core diameter incorrectly programmed
%1 = Channel number
%2 = Block number, label
The nominal or core diameter was incorrectly programmed. Alarm triggered by following
cycles: CYCLE70, E_MI_TR, F_MI_TR.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check thread geometry.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 internal/external thread type not defined
%1 = Channel number
%2 = Block number, label
The thread type (internal/external) was not defined. Alarm triggered by following cycles:
CYCLE70.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
The internal/external thread type must be entered.
Clear alarm with the RESET key. Restart part program
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04