Siemens SINUMERIK 840D Diagnostics Manual page 213

10.04
Remedy:
Program Continuation:
14542
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14543
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14544
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14545
Parameters:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Change tool definition
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 contour tool: the min. limit angle has not been programmed
%1 = Channel number
%2 = Block number, label
On defining a contour tool, either no limit angle must be indicated, or both the minimum
and the maximum limit angle must be programmed once for each.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Change tool definition
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 contour tool: the max. limit angle has not been programmed
%1 = Channel number
%2 = Block number, label
On defining a contour tool, either no limit angle must be indicated, or both the minimum
and the maximum limit angle must be programmed once for each.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Change tool definition
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 contour tool: edge D%3 is not positioned between the two
border edges
%1 = Channel number
%2 = Block number, label
%3 = Edge number, label
On defining a form tool with limit, all edges must be positioned between the edge with the
minimum limit angle and the edge with the maximum limit angle when rotating counter-
clockwise.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Change tool definition
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 contour tool: edge D%3 completely encircles edge D%4
%1 = Channel number
%2 = Block number, label
%3 = Edge number, label
%4 = Edge number, label
1 Alarms
1-213