Siemens SINUMERIK 840D Diagnostics Manual page 618

1 Alarms
Reactions:
Remedy:
Program Continuation:
301708
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
301709
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
301710
Parameters:
Definitions:
1-618
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Change parameterization of
the cam modulo range in MD 1305: $MD_SAFE_MODULO_RANGE (actual value range
for safe cam with rotary axes).
Switch control OFF - ON.
Axis %1 drive %2 actual value synchronisation not allowed
%1 = NC axis number
%2 = Drive number
The actual value synchronization for drift/slippage in MD 1301:
$MD_SAFE_FUNCTION_ENABLE (safe functions enable) is deselected. This is only
allowed with SBH/SG monitoring, since the absolute actual position is irrelevant for this
type of monitoring. However, safe end position and/or cam monitoring is also selected.
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Deselect actual value syn-
chronization for drift/slippage or the safe end position and/or safe cam monitoring in MD
1301: $MD_SAFE_FUNCTION_ENABLE (safe functions enable).
Switch control OFF - ON.
Axis %1 drive %2 submodule with integrated linearization invalid
%1 = NC axis number
%2 = Drive number
If a submodule with integrated linearization is used, all submodules on the module must
use the integrated linearization. A submodule with integrated lineearization was found.
However, not all submodules have this linearization.
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Replace the submodule.
Switch control OFF - ON.
Axis %1 drive %2 resolution SSI motor measuring system invalid
%1 = NC axis number
%2 = Drive number
The configuration of the motor measuring system for an SSI encoder is incorrect:
MD_1022 $MD_ENC_ABS_RESOL_MOTOR must not be 0.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04