Siemens SINUMERIK 840D Diagnostics Manual page 266

1 Alarms
Definitions:
Reactions:
Remedy:
Program Continuation:
16797
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16798
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16799
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-266
A coupling is to be switched the parameters of which have neither been programmed nor
configured.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Please inform the authorized personnel/service department. Correct NC part program or
MD, program the coupling with COUPDEF or configure by means of MD.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 coupling is active
%1 = Channel number
%2 = Block number, label
An operation is to be performed in which no coupling may be active, e.g. COUPDEL or
TANGDEL must not be used on active couplings.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Correct NC part program, deselect the link with COUPOF or TANGOF.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 axis %3 is following axis and prohibits axis container rota-
tion
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
The programmed axis/spindle is active as a slave axis/spindle in a coupling. When the
coupling is active, the axis container cannot be rotated.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program. Deactivate the coupling(s) for this axis/spindle before rotating the
axis container or execute the axis container rotation at a later time.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 axis %3 is master axis and prohibits axis container rotation
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
The programmed axis/spindle is active as a master axis/spindle in a coupling. When the
coupling is active, the axis container cannot be rotated.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program. Deactivate the coupling(s) for this axis/spindle before rotating the
axis container or execute the axis container rotation at a later time.
Clear alarm with NC START or RESET key and continue the program.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04