Siemens SINUMERIK 840D Diagnostics Manual page 674

1 Alarms
No. 72
Explanation
Not allowed if
Remedy
No. 73
Explanation
Not allowed if
Remedy
No. 74
Explanation
Not allowed if
Remedy
No. 75
Explanation
Not allowed if
Remedy
No. 76
Explanation
Not allowed if
Remedy
No. 77
Explanation
Not allowed if
Remedy
No. 78
Explanation
Not allowed if
Remedy
No. 79
Explanation
Not allowed if
Remedy
No. 80
Explanation
Not allowed if
Remedy
No. 81
Explanation
Not allowed if
Remedy
1-674
Stop at the end of block preparation with subsequent reorganization of block processing
(alarm).
Nesting depth too great.
> Wait until the preceding ASUB is complete or abort the program.
Conditional stop at block end. (If, after continuation by means of an NC start, there is still
a reason to stop "Stop at block end", the program stops again.)
-
-
Conditional stop at block end. Despite the start, the interpreter or the preprocessing does
not manage to put a block in main run.
-
-
Stop preprocessing (alarm).
-
-
Retraction with G33 and Stop.
-
-
Conditional wait for program marker (NC block: WAITMC).
-
-
Set marker (NC block: SETM).
-
-
Clear marker (NC_block: CLEARM).
-
-
Selection of an NC block (PI command).
-
-
Disable the NC program currently being processed for editing (PI command).
-
-
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
03.04