Siemens SINUMERIK 840D Diagnostics Manual page 233

10.04
Definitions:
Reactions:
Remedy:
Program Continuation:
14840
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14900
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14910
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14920
Parameters:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
G97 has been programmed in the displayed block although G96 was not (or G97 already)
active previously.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remove G97 from the displayed block and program the correct feed type (G93, G94, G95
or G96) for the machining section which follows.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 incorrect value range for constant cutting speed
%1 = Channel number
%2 = Block number, label
The programmed cutting speed is not within the input range
Input range metric: 0.01 to 9 999.99 [m/min]
Input range inch: 0.1 to 99 999.99 [inch/min].
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Program cutting speed under address S within the permissible range of values.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 center point and end point programmed simultaneously
%1 = Channel number
%2 = Block number, label
When programming a circle by means of the opening angle, the circle center point was
programmed together with the circle end point. This is too much information for the circle.
Only one of the two points is allowed.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Select the programming variant guaranteeing that the dimensions are definitely taken
over from the workpiece drawing (avoidance of calculation errors).
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 invalid angle of aperture for programmed circle
%1 = Channel number
%2 = Block number, label
When programming a circle by means of the opening angle, a negative opening angle or
an opening angle greater than or equal to 360 degrees has been programmed.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Program opening angle within the allowed range of values between 0.0001 and 359.9999
[degrees].
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 intermediate point of circle incorrect
%1 = Channel number
%2 = Block number, label
1 Alarms
1-233