Siemens SINUMERIK 840D Diagnostics Manual page 327

10.04
20106
Definitions:
Reactions:
Remedy:
Program Continuation:
20108
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
20109
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
20120
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Emergency stop set by the digitizer
The digitizing unit has recognized a serious error and triggered an emergency stop.
Cause: See display on the digitizing unit.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
-
Clear alarm with the RESET key. Restart part program
Invalid data package received from the digitizer. Error codes %1, %2
%1 = Error code of cyclic packet
%2 = Error code of out-of-band packet
A data packet received by the digitizing unit could not be evaluated.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Error code: 0, 0: Check cable
connection leading to the NC. Other error codes: e.g. wrong header, incorrect checksum
(development documentation).
Clear alarm with the RESET key. Restart part program
Error in communication with the digitizer: status code of com-circuit: %1
%1 = Status byte
The circuit for serial communication with the digitizing unit signals a transmission error via
its status byte (framing error, parity etc.).
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Check connection cable
leading to the digitizing unit: In particular screening.
Clear alarm with the RESET key. Restart part program
Axis %1: too many compensation relations
%1 = Axis name, spindle number
Interpolatory compensation with tables. For each axis, the maximum number of compen-
sation relationships defined may be no more than the number of axes in the system. In
this alarm, the interpolatory compensation in the axis is switched off automatically.
- Interface signals are set.
- Alarm display.
Check table parameters $AN_CEC_OUTPUT_AXIS and correct and/or switch off one or
more tables ($SN_CEC_TABLE_ENABLE).
Clear alarm with the RESET key. Restart part program
1 Alarms
1-327