Siemens SINUMERIK 840D Diagnostics Manual page 495

10.04
101161
Definitions:
Remedy:
Program Continuation:
101162
Definitions:
Remedy:
Program Continuation:
101163
Definitions:
Remedy:
Program Continuation:
101164
Definitions:
Remedy:
Program Continuation:
101165
Definitions:
Remedy:
Program Continuation:
101166
Definitions:
Remedy:
Program Continuation:
101167
Definitions:
Remedy:
Program Continuation:
101168
Definitions:
Remedy:
Program Continuation:
101200
Definitions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
The drive is not in cyclic mode!
The start-up is not completely carried out, therefore, the function "Calculate motor data"
cannot be selected.
--
Internal
MDx134/MDx400 MOTOR_NOMINAL_FREQUENCY/MOTOR_RATED_SPEED imper-
missible
--
--
Internal
MDx130 MOTOR_NOMINAL_POWER <= 0
--
--
Internal
MDx132 MOTOR_NOMINAL_VOLTAGE <= 0
--
--
Internal
MDx103 MOTOR_NOMINAL_CURRENT <= 0
--
--
Internal
MDx129 POWER_FACTOR_COS_PHI impermissible
--
--
Internal
MDx134/MDx400 MOTOR_NOMINAL_FREQUENCY/MOTOR_RATED_SPEED imper-
missible
--
--
Internal
Warning MDx142 FIELD_WEAKENING_SPEED < MDx400 MOTOR_RATED_SPEED
--
--
Internal
Safety-Integrated data copied
The SI data copying function was successful.
--
Internal
1 Alarms
1-495