Siemens SINUMERIK 840D Diagnostics Manual page 490

1 Alarms
101008
Parameters:
Definitions:
Remedy:
Program Continuation:
101013
Definitions:
Remedy:
Program Continuation:
101016
Definitions:
Remedy:
Program Continuation:
101017
Definitions:
Remedy:
Program Continuation:
101018
Definitions:
Remedy:
Program Continuation:
101100
Definitions:
Remedy:
Program Continuation:
101111
Definitions:
Remedy:
Program Continuation:
101112
Definitions:
Remedy:
Program Continuation:
1-490
Current access level: %1
%1 = Access-level system, manufacturer, service or user.
When selecting the alarm image, the current access level is displayed: system, manufac-
turer, service or user or keyswitch positions 3/2/1/0.
--
Internal
Input error - see help - (i)-key
PLC status A syntax error occurred while entering a value in the PLC status.
The input syntax is explained in a help image.
--
Internal
Error: The operand address is greater than 65535!!
The value range of the operand address was exceeded.
Use a smaller value range for the operand address.
Internal
No PLC input screen forms found!
There are no *.plc input screen forms in the target system.
--
Internal
Reading-in only possible in an active PLC status!
The current PLC status mode is not active, e.g. if the softkey "Change" was pressed.
Switch the PLC status to active.
Internal
No access authorization!
The access level set is too low to open the selected window.
Enter a higher password.
Internal
No axes configured!
Due to an incomplete start-up, the image "Service axis" or "Axis machine data" cannot be
selected.
Complete start-up.
Internal
No drives configured!
Due to an incomplete start-up, the image "Service drive" cannot be selected.
Complete start-up.
Internal
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04