Siemens SINUMERIK 840D Diagnostics Manual page 667

03.04
No. 12
Explanation
Not allowed if
Remedy
No. 13
Explanation
Not allowed if
Remedy
No. 14
Explanation
Not allowed if
Remedy
No. 15
Explanation
Not allowed if
Remedy
No. 16
Explanation
Not allowed if
Remedy
No. 17
Explanation
Not allowed if
Remedy
No. 18
Explanation
Not allowed if
Remedy
No. 19
Explanation
Not allowed if
Remedy
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Perform a user interrupt at the end of the block (VDI signal: ASUB interface, digital-analog
interface).
See 10
-
Perform a rapid retraction (VDI signal: Digital-analog interface and ASUB interface, for
further actions see 10, 11, 12, 85, 86).
-
-
Move tool - only with tool management (PI command).
-
-
Perform deletion of distance-to-go or axis synchronization (VDI signal: deletion of dis-
tance-to-go or follow-up mode) (follow-up mode: e.g., on activation of axis motion).
1. The nesting depth is too great.
2. The active block, after which deceleration takes place, cannot be reorganized (occurs
when deceleration takes place over several blocks).
> Abort the program.
> Abort the program.
Abort repetition of subroutine (VDI signal: Delete number of subroutine repetitions).
1. The nesting depth is too great.
2. The active block, after which deceleration takes place, cannot be reorganized
(occurs when deceleration takes place over several blocks).
> Abort the program.
> Abort the program.
Abortion of subroutine processing (VDI signal: Program-level abort).
1. The nesting depth is too great.
2. The active block, after which deceleration takes place, cannot be reorganized (occurs
when deceleration takes place over several blocks).
> Abort the program.
> Abort the program.
Activate single block (VDI signal: Activate single block).
-
-
Deactivate single block (VDI signal: Activate single block).
-
-
1 Alarms
1-667