Siemens SINUMERIK 840D Diagnostics Manual page 107

10.04
Reactions:
Remedy:
Program Continuation:
10731
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10740
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10741
Parameters:
Definitions:
Reactions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
a) Check NC program for correct positional data and, if necessary, make corrections.
b) Check zero offsets (current frame)
c) Correct working area limitation via G25, or
d) Correct working area limitation via setting data, or
e) Deactivate working area limitation via setting data 43410
WORKAREA_MINUS_ENABLE=FALSE
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %3 axis %2 working area limitation %4
%1 = Channel number
%2 = Axis name, spindle number
%3 = Block number, label
%4 = String ( + or - )
For the axis, the planned motion violates the working area limit. The alarm is activated
during the preparation of approach or rest blocks at REPOS.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
Abort part program with reset.
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 too many empty blocks in WAB programming
%1 = Channel number
%2 = Block number, label
It is not allowed to program more blocks than specified by machine data
MC_WAB_MAXNUM_DUMMY_BLOCKS between the WAB block and the block deter-
mining the approach and retraction tangent.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 direction reversal with WAB infeed motion
%1 = Channel number
%2 = Block number, label
A safety distance which has been programmed is located perpendicular to the machining
plane and not between the start and end point of the WAB contour.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
1 Alarms
1-107