Siemens SINUMERIK 840D Diagnostics Manual page 419

10.04
61011
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61012
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61013
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61016
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 block %2 scaling not allowed
%1 = Channel number
%2 = Block number, label
A scale factor is active which is illegal for this cycle. Alarm triggered by following cycles:
CYCLE71, CYCLE72.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Modify scale factor.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 different scaling on the plane
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycles: CYCLE76, CYCLE77.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
--
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 basic settings were changed, program cannot be executed
%1 = Channel number
%2 = Block number, label channel number
The basic settings are not compatible with the generated program. Alarm triggered by fol-
lowing cycles: E_CP_CE, E_CP_CO, E_CP_DR, F_CP_CE, F_CP_CO, F_CP_DR.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check and, if necessary, change the basic settings.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 System frame for cycles is missing
%1 = Channel number
%2 = Block number, label channel number
--
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Set MD 28082: MM_SYSTEM_FRAME_MASK, Bit 5=1.
Clear alarm with the RESET key. Restart part program
1 Alarms
1-419