Siemens SINUMERIK 840D Diagnostics Manual page 18

1 Alarms
Remedy:
Program Continuation:
1017
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1018
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1019
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-18
Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Clear alarm with the RESET key in all channels of this mode group. Restart part program.
Channel %1 axis %2 system error %3
%1 = Channel number
%2 = Axis number
%3 = System error number
With this alarm, internal alarm states are displayed that, in conjunction with the trans-
ferred error number, provide information on the cause and location of the error.
- Alarm display.
Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Clear alarm with the Delete key or NC START.
Floating point arithmetic error in channel %1 task %2 station %3 FPU state %4
%1 = Channel number
%2 = Task ID
%3 = Station priority
%4 = FPU status
The floating point unit of the processor has found a computational error.
- NC not ready.
- Mode group not ready, also effective for single axes
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
- Alarm reaction delay is canceled.
Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Clear alarm with the RESET key in all channels of this mode group. Restart part program.
Floating point arithmetic error at address %3 in channel %1 task %2 FPU state %4
%1 = Channel number
%2 = Task ID
%3 = Code address of operation that triggered the error
%4 = FPU status
The floating point unit of the processor has triggered an exception on account of a compu-
tational error.
- NC not ready.
- Mode group not ready, also effective for single axes
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
- Alarm reaction delay is canceled.
Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Clear alarm with the RESET key in all channels of this mode group. Restart part program.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04