Siemens SINUMERIK 840D Diagnostics Manual page 458

1 Alarms
61408
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61409
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61410
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61411
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61412
Parameters:
1-458
Channel %1 block %2 Sum correction not available
%1 = Channel number
%2 = Block number, label channel number
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Set MD 18080, Bit 8=1
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Setup offsets not available
%1 = Channel number
%2 = Block number, label channel number
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Set MD 18112, Bit 4=1
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Option or offset variable not available
%1 = Channel number
%2 = Block number, label channel number
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
The variable to be corrected requires an option or an increase in MD values.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Frame calculation not possible, check the values
%1 = Channel number
%2 = Block number, label channel number
The alarm is triggered by the following cycles: CYCLE997, CYCLE119
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check the setpoint and actual values
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Channel base frame not available
%1 = Channel number
%2 = Block number, label channel number
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04