Siemens SINUMERIK 840D Diagnostics Manual page 472

1 Alarms
62310
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
62311
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
63000
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
65000
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-472
Channel %1 block %2 The max. number of characters per line is limited to 200 char-
acters per line
%1 = Channel number
%2 = Block number, label channel number
The alarm is triggered by the following cycles: CYCLE105
Max. number of characters per line has been limited to 200 characters per line.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
--
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 The max. number of characters per line _PROTFORM[1] is
adjusted
%1 = Channel number
%2 = Block number, label channel number
The alarm is triggered by the following cycles: CYCLE105
Max. number of characters per line _PROTFORM[1] has been adjusted.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
--
Clear alarm with the RESET key. Restart part program
Channel %1 block %2
%1 = Channel number
%2 = Block number, label
--
- Alarm display.
--
Clear alarm with the Delete key or NC START.
Channel %1 block %2
%1 = Channel number
%2 = Block number, label
References: The current alarm text, the error description and the remedial measures for
the user cycle alarms can be found in the Programming Guide of the machine manufac-
turer.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Refer to the manual on user cycles.
Clear alarm with the RESET key. Restart part program
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04