Siemens SINUMERIK 840D Diagnostics Manual page 456

1 Alarms
61373
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61401
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61402
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61403
Parameters:
Definitions:
Reactions:
1-456
Channel %1 block %2 Mono-directional probe requires SPOS-capable spindle
%1 = Channel number
%2 = Block number, label channel number
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check machine equipment.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Probe not switching, traversing path limitation through soft-
ware limit position
%1 = Channel number
%2 = Block number, label channel number
The alarm is triggered by the following cycles: CYCLE961, CYCLE971, CYCLE976,
CYCLE977, CYCLE978, CYCLE998
The position defined by a setpoint value cannot be reached, as the software limit position
has been exceeded.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Probe collision, traversing path limitation through software
limit position
%1 = Channel number
%2 = Block number, label channel number
The alarm is triggered by the following cycles: CYCLE977
For the measuring variant Measure web/shaft, the position path in the plane was limited
by the software limit position. The probe switched in the following infeed along the infeed
axis.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Internal cycle error with frame calculation
%1 = Channel number
%2 = Block number, label channel number
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04