Siemens SINUMERIK 840D Diagnostics Manual page 160

1 Alarms
Remedy:
Program Continuation:
12550
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
12552
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-160
Press the NC Stop key and select the function "Correction block" with the softkey PRO-
GRAM CORRECT. The correction pointer positions on the incorrect block.
Divide up the program block into several subblocks.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 name %3 not defined or option not installed
%1 = Channel number
%2 = Block number, label
%3 = Source symbol
The identifier displayed has not been defined before being used.
Macro: The keyword, to be defined with the DEFINE ... AS ... statement, is missing in one
file:
_N_SMAC_DEF
_N_MMAC_DEF
_N_UMAC_DEF
_N_SGUD_DEF
_N_MGUD_DEF
_N_UGUD_DEF
Variable: DEF statement is missing
Program: PROC declaration is missing
- Correction block
- Interface signals are set.
- Alarm display.
Press the NC Stop key and select the function "Correction block" with the softkey PRO-
GRAM CORRECT. The correction pointer positions on the incorrect block.
• Correct the name used (writing error)
• Check definitions of variables, subroutines and macros
• Declare subroutine with EXTERN, load subroutine to SPF-Dir
• Check interface definition of subroutine
• Check options
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 tool/magazine OEM parameter not defined. Option not set.
Option not set.
%1 = Channel number
%2 = Block number, label
The programmed $TC_... Cx system variable is not known in the control.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
• Correct the name used (writing error)
• $TC_DPCx, $TC_TPCx, $TC_MOPCx, $TC_MAPCx, $TC_MPPCx, $TC_DPCSx,
$TC_TPCSx, $TC_MOPCSx, $TC_MAPCSx, $TC_MPPCSx; with x=1,...10
• These are the OEM parameters of the tools magazines, The corresponding machine
data value is set to < 10, or the option 'TM OEM parameters' has not been set.
• Use correct parameter number, or - if the name cannot be changed - set machine data
correction (see $MN_MM_NUM_CC_TOA_PARAM, ...
$MN_MM_NUM_CCS_TOA_PARAM, ...)
• Check the option (machine data are only effective when the option is enabled).
Clear alarm with NC START or RESET key and continue the program.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04