System Reactions On Alarms - Siemens SINUMERIK 840D Diagnostics Manual

03.04
1.5
Names
Effect
Names
Effect
Names
Effect
Names
Effect
Names
Effect
Names
Effect
Names
Effect
Names
Effect
Names
Effect
Names
Effect
Names
Effect
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition

System reactions on alarms

COMPBLOCKWITHREORG
Block preparation has detected an error, which can be rectified by modifying the program.
Reorganization follows program modification.
- Compensation block is also reorganized.
COMPENSATIONBLOCK
Block preparation has detected an error, which can be rectified by modifying the program.
- Compensation block
FOLLOWUP
Axes are tracked.
- NC switches to follow-up mode.
INTERPRETER STOP
Program execution is aborted after all the prepared blocks (interpolator buffer) have been
processed.
- Interpreter stop
LOCALREACTION
- Local alarm reaction
NOALARMREACTION
- No alarm reaction
NOREADY | NCKREACTIONVIEW
NCK ready off: Active rapid deceleration (i.e., with maximum braking current) of all drives
Clearing of servo enable for all NC axes Release of NC ready relay.
- NC not ready.
NOREADY | BAGREACTIONVIEW
Mode group ready off: Active rapid deceleration (i.e., with maximum braking current) of
the drives in this mode group Clearing of servo enable for the NC axes concerned.
- Mode group not ready.
NOREADY
Channel ready off: Active rapid deceleration (i.e., with maximum braking current) of the
drives in this channel Clearing of servo enable for the NC axes concerned.
- Channel not ready.
NONCSTART
It is not possible to start a program in this channel.
- NC start disable in this channel
NOREFMARK
The axes in this channel need to be rereferenced.
- Rereference the axes in this channel.
1 Alarms
1-689