Rear Window Wiper And Washer Switch (Outback) - Subaru Outback 2016 Manual

3-70
Instruments and controls/Wiper and washer
Windshield washer fluid warning indicator
NOTE
The windshield washer fluid warning
indicator appears when the washer
fluid level in the tank has dropped to
the lower limit. If the warning indicator
appears, refill the tank with fluid. For
the tank refilling method, refer to
"Windshield washer fluid" F11-41.
NOTE
If your vehicle is equipped with a
headlight washer, pulling the wiper
control lever for more than 1 second
also causes the headlight washer to
operate under the following conditions.
. when the light switch is in the "
position (except Australia models)
. when the light switch is in the "
position (Australia models)
. when the light switch is in the
"AUTO" position and the headlights
illuminate automatically (models with
auto on/off headlights)
For further details, refer to "Headlight
washer" F3-73.
& Rear window wiper and
washer switch (Outback)
The wiper operates only when the ignition
switch is in the "ON" position.
1) Except Australia models
2) Australia models
: Washer (accompanied by wiper operation)
"
/ HI: Continuous
/ LO: Intermittent
"
/ OFF: Off
: Washer (accompanied by wiper operation)
! Rear wiper
To turn the rear wiper on, turn the knob
switch upward.
To turn the wiper off, return the knob
switch to the " "/"OFF" position.
With the switch turned to the "
position, the rear wiper will operate inter-
mittently at intervals corresponding to the
vehicle speed. In this position, when you
move the select lever to the "R" position
(CVT models) or the shift lever to the
reverse position (MT models), the rear
wiper will switch to continuous operation.
When you move the select lever/shift lever
from the "R" (reverse) position to another
position, the rear wiper will return to
intermittent operation.
CAUTION
Do not attach anything that disturbs
the rear wiper operation on the rear
gate. Doing so may damage the rear
wiper when it operates.
NOTE
Even if the rear wiper switch is in the
off position, while the select lever is in
the "R" position with the windshield
wiper operating continuously, the rear
"/"LO"