Figure 3-3 Kigeneral Project Imported Into The Test Script Builder - Keithley SourceMeter 2611 User Manual

3-8 Test Script Processor Interaction
Figure 3-3
KIGeneral project imported into the Test Script Builder
Step 2: Modifying the test code for the SourceVMeasureI function
As shown in
tab for the "main.tsp" script file. The test code for all of the functions of the
KIGeneral factory script are in this tab. Use the scroll buttons on the right side of
the tab to view more code.
Editing example
The following line of code in the "main.tsp" script file applies to the
SourceVMeasureI
92
The above command defines a display input field and message prompt for
entering the bias voltage. The -40 parameter sets the minimum voltage that can
be entered, and the 40 parameter sets the maximum voltage that can be entered.
2600S-900-01 Rev. A / May 2006
Series 2600 System SourceMeters User's Manual
Figure 3-3, the test code for the script functions is contained in the
function:
bias = display.prompt("+00.000", " Seconds", "Enter
BIAS Voltage.", 0, -40, 40)
Return to In this section: