Show Atmf Area Nodes-Detail - Allied Telesis x310-26FT Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT
-
SHOW ATMF AREA NODES DETAIL

show atmf area nodes-detail

Overview Use this command to display detailed information about an AMF controller's
remote nodes.
Note that this command can only be run from a controller node.
Syntax show atmf area nodes-detail [<area-name> [<node-name>]]
Mode Privileged Exec
Usage If you do not limit the output to a single area or node, this command displays
information about all remote nodes that the controller is aware of. This can be a
very large number of nodes.
Example To show information about all the nodes the controller is aware of, use the
command:
controller-1#
The following figure shows partial example output from running this command.
Table 13: Output from the show atmf area nodes-detail command
C613-50103-01 REV A
™ (AMF) C
RAMEWORK OMMANDS
Parameter Description
<area-name>
Displays detailed information about nodes in the specified area.
<node-name>
Displays detailed information about the specified node.
show atmf area nodes-detail
controller-1#show atmf area nodes-detail 

Wellington Area Node Information: 
Node name well-gate
Parent node name
Domain id
Board type
Distance to core
Flags
Extra flags
MAC Address

Node name well-master 
Parent node name
Domain id
Board type
Distance to core
Flags
Extra flags
MAC Address

...
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
: well-master 
: well-gate's domain 
: 368 
: 1 
: 50 
: 0x00000006 
: 001a.eb56.9020 
: none 
: well-master's domain 
: 333 
: 0 
: 51 
: 0x0000000c 
: eccd.6d3f.fef7
2118