Atmf Provision Node Delete - Allied Telesis x310-26FT Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT

ATMF PROVISION NODE DELETE

atmf provision node delete
Overview This command deletes files that have been created for loading onto a provisioned
node. It can only be run on master nodes.
atmf provision node <nodename> delete
Syntax
Mode Privileged Exec
Usage This command is only available on master nodes in the AMF network. The
command will only work if the provisioned node specified in the command has
already been set up (although the device itself is still yet to be installed). Otherwise,
an error message is shown when the command is run.
You may want to use the atmf provision node delete command to delete a
provisioned node that was created in error or that is no longer needed.
This command cannot be used to delete backups created by the AMF backup
procedure. In this case, use the command
NOTE
referenced by the
entries.
Example To delete backup files for a provisioned node named device3 use the command:
device1#
To confirm that the backup files for provisioned node device3 have been deleted
use the command:
device1#
The output should show that the provisioned node device3 no longer exists in the
backup file, as shown in the figure below:
C613-50103-01 REV A
™ (AMF) C
RAMEWORK OMMANDS
Parameter
<nodename>
: This command allows provisioned entries to be deleted even if they have been
atmf provision
atmf provision node device3 delete
show atmf backup
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
The name of the provisioned node to be deleted.
atmf backup delete
command, so take care to only delete unwanted
to delete the files.
2073