Modeltype - Allied Telesis x310-26FT Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT

MODELTYPE

modeltype
Overview This command sets the expected model type of the guest node. Guest nodes can
be one of various types: alliedware, aw+, tq or other. The model type will default to
other if nothing is set.
Use the no variant of this command to reset the model type to other.
Syntax modeltype [alliedware|aw+|tq|other]
Default Will default to other
Mode ATMF Guest Configuration Mode
Example 1 To assign the model type tq to the guest-class called tq_device, use the following
commands:
node1#
node1(config)#
node1(config-atmf-guest)#
node1(config-atmf-guest)#
Example 2 To remove the model type tq from the guest-class called tq_device, and reset it to
the default of other, use the following commands:
node1#
node1(config)#
node1(config-atmf-guest)#
node1(config-atmf-guest)#
Related atmf guest-class
Commands
switchport atmf-guestlink
show atmf links guest
C613-50103-01 REV A
™ (AMF) C
RAMEWORK OMMANDS
Parameter Description
alliedware
A legacy Allied Telesis operating system.
aw+
The Allied Telesis AlliedWare Plus operating system.
tq
An Allied Telesis TQ Series wireless access point.
other
Used where the model type is outside the above definitions.
conf t
atmf guest-class tq_device
conf t
atmf guest-class tq_device
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
modeltype tq
end
no modeltype
end
2104