Switchport Atmf-Link - Allied Telesis x310-26FT Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT
-
SWITCHPORT ATMF LINK

switchport atmf-link

Overview This command enables you to configure a port or aggregator to be an AMF
uplink/downlink. Running this command will automatically place the port or
aggregator into trunk mode.
Use the no variant of this command to remove any AMF-link that may exist for the
selected port or aggregated link.
switchport atmf-link
Syntax
no switchport atmf-link
Mode Interface Configuration for a switchport, a static aggregator or a dynamic channel
group.
Example To make a switchport 1.0.1 an AMF uplink/downlink, use the following commands
Node_1#
Node_1(config)#
Node_1(config-if)#
C613-50103-01 REV A
™ (AMF) C
RAMEWORK OMMANDS
configure terminal
interface port1.0.1
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
switchport atmf-link
2174