Http-Enable - Allied Telesis x310-26FT Command Reference Manual

X310 series stackable access switches for alliedware plus version 5.4.6-1.x
Table of Contents

Advertisement

A
T
M
F
LLIED
ELESIS
ANAGEMENT
-
HTTP
ENABLE

http-enable

Overview
This command is used to enable GUI access to a guest node. When http-enable is
configured the port number is set to its default of 80. If the guest node is using a
different port for HTTP, you can configure this using the port <PORTNO> attribute.
This command is used to inform the GUI that this device has an HTTP interface at
the specified port number so that a suitable URL can be provided to the user.
Use the no variant of this command to disable HTTP.
http-enable [port <PORTNO>]
Syntax
no http-enable
http-enable is off. 
Default
If http-enable is selected without a port parameter the port number will default to
80.
Mode
ATMF Guest Configuration Mode
Example 1
To enable HTTP access on port 80 (the default) of a guest node, use the following
commands:
node1#
node1(config)#atmf guest-class Camera
node1(config-atmf-guest)#http-enable
node1(config-atmf-guest)#
Example 2
To enable HTTP access on port 400 of a guest node, use the following commands:
node1#
node1(config)#atmf guest-class Camera
node1(config-atmf-guest)#http-enable port 400
node1(config-atmf-guest)#
Example 3
To disable HTTP access of a guest node, use the following commands:
node1#
node1(config)#atmf guest-class Camera
node1(config-atmf-guest)#no http-enable
node1(config-atmf-guest)#
C613-50103-01 REV A
™ (AMF) C
RAMEWORK
OMMANDS
Parameter
Description
port
TCP port number.
<PORTNO>
The port number to be configured.
conf t
conf t
conf t
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
2102

Advertisement

Table of Contents
loading

This manual is also suitable for:

X310-26fpX310-50fpX310-50ft

Table of Contents