Erase Factory-Default - Allied Telesis x310-26FT Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT
-
ERASE FACTORY DEFAULT

erase factory-default

Overview This command erases all data from NVS and all data from flash excluding the
following:
•
•
•
•
The device is then rebooted and returns the device to its factory default condition.
The device can then be used for automatic node recovery.
erase factory-default
Syntax
Mode Global Configuration.
Usage This command is an alias to the
Example To erase data, use the command:
Node_1(config)#
This command will erase all NVS, all flash contents except for
the boot release, and any license files, and then reboot the
switch. Continue? (y/n):y
Related atmf cleanup
Commands
C613-50103-01 REV A
™ (AMF) C
RAMEWORK OMMANDS
The current release file and its /flash/.release file
The backup release file and /flash/.backup file
v1 license files /flash/.configs/.swfeature.lic
v2 license files /flash/.configs/.sw_v2.lic
erase factory-default
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
atmf cleanup command.
2101