Default-Router - Allied Telesis x310-26FT Command Reference Manual

D H C
YNAMIC OST ONFIGURATION
-
DEFAULT ROUTER

default-router

Overview This command adds a default router to the DHCP address pool you are configuring.
You can use this command multiple times to create a list of default routers on the
client's subnet. This sets the router details using the pre-defined option 3. Note
that if you add a user-defined option 3 using the option command, then you will
override any settings created with this command.
The no variant of this command removes either the specified default router, or all
default routers from the DHCP pool.
default-router <ip-address>
Syntax
no default-router [<ip-address>]
Mode DHCP Configuration
Examples To add a router with an IP address 192.168.1.2 to the DHCP pool named P2, use the
following commands:
awplus#
awplus(config)#
awplus(dhcp-config)#
To remove a router with an IP address 192.168.1.2 to the DHCP pool named P2, use
the following commands:
awplus#
awplus(config)#
awplus(dhcp-config)#
To remove all routers from the DHCP pool named P2, use the following commands:
awplus#
awplus(config)#
awplus(dhcp-config)#
C613-50103-01 REV A
P (DHCP) C
ROTOCOL OMMANDS
Parameter
<ip-address>
configure terminal
ip dhcp pool P2
configure terminal
ip dhcp pool P2
configure terminal
ip dhcp pool P2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
IPv4 address of the default router, in dotted decimal notation.
default-router 192.168.1.2
no default-router 192.168.1.2
no default-router
2185