Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 1483

QoS Commands
-> show qos port 4/7
Slot/ QoS
Port Act Enabled
4/7 Yes Yes
output definitions
Slot/Port
QoS
Act
Enabled
Trust
Default P
Default DSCP
Default Queues
Tot Queues
Physical Bandwidth
Max Reserved Bandwidth
Clsfy
Type
Release History
Release 6.6.1; command was introduced.
Related Commands
qos port
MIB Objects
alaQoSPortTable
alaQoSPortSlot
alaQoSPortPort
alaQoSPortEnabled
alaQoSPortDefault8021p
alaQoSPortDefaultDSCP
alaQoSPortDefaultQueues
alaQoSPortMaximumReservedBandwidth
alaQoSPortMaximumDefaultBandwidth
alaQoSPortDefaultClassification
alaQoSClassify
alaQoSClassifySourceInterfaceType
OmniSwitch CLI Reference Guide
Deflt Queues
Trust P/DSCP Deflt
No 0/ 0 8
The slot and physical port number.
Whether or not the interface supports QoS.
Whether or not the port is sending/receiving QoS traffic.
Whether or not the port is enabled for QoS.
Whether the port is trusted or not trusted.
The default 802.1p setting for the port.
The default ToS/DSCP setting for the port.
The number of default queues.
The total number of queues.
The amount of physical bandwidth available on the port.
Displays the amount of bandwidth reserved and whether it is physical
(<phy>) or maximum virtual port bandwidth (<max>).
The default classification setting on a high-density gigabit port (p for
802.1p; t for ToS; d for DSCP). The field displays a hyphen (-) if the
port is not located on a high-density gigabit interface.
The interface type, ethernet or wan.
Configures a physical port for QoS.
November 2009
Bandwidth
Tot Physical Max Reserved
0 100M -
Clsfy Type
-/<phy> - ethernet-100
page 38-55