qos port
Configures QoS parameters for a physical port. This section describes the base command with a single
required option (slot/port).
In lieu of these options, the base command (qos port) may be used with other keywords to set up a QoS
configuration on a per port basis. These keywords are listed here and described as separate commands later
in this chapter. In addition, some keywords have a no form to remove the parameter or return it to its
default.
qos port slot/port
[servicing mode]
[trusted]
[maximum bandwidth]
[default 802.1p value]
[default dscp value]
[default classification {802.1p | tos | dscp}]
Syntax Definitions
slot/port
Defaults
•
Mobile ports and ports enabled for 802.1Q are always trusted; by default, any other ports are not
trusted.
•
By default, QoS ports do not preempt queues of lower priority.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use the trusted option to change the trust mode for the port.
Examples
-> qos port 3/1 trusted
-> qos port 4/2 no trusted
Release History
Release 6.6.1; command was introduced.
page 38-36
The physical slot and port number. For example: 4/1.
OmniSwitch CLI Reference Guide
QoS Commands
November 2009