Main Switch Test
1. Remove the driver's switch panel (see
DRIVER'S SWITCH PANEL
2. Remove the TCS and cruise main switch assembly
from the driver's switch panel.
3.
Check for continuity between the terminals in each
switch position according to the table.
If there is no continuity, replace the switch.
section
20).
TCS SWITCH
CRUISE
MAIN
SWITCH
BULBS
(0.84 W x 2)
Brake Pedal Position Switch Test
1.
Disconnect the 4P connector from the switch.
2.
Check for continuity between the terminals accord-
ing to the table.
3.
If necessary, replace the switch or adjust pedal height
(see
section
19).
Terminal side of
male terminals
4P CONNECTOR
BRAKE PEDAL