Adding Or Replacing A Member Switch Or An External Routing Engine In An Ex8200 Virtual Chassis (Cli Procedure) - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Related
Documentation
Adding or Replacing a Member Switch or an External Routing Engine in an EX8200
Virtual Chassis (CLI Procedure)
Copyright © 2010, Juniper Networks, Inc.
NOTE: An EX8200 Virtual Chassis does not function properly when an
external Routing Engine is configured to use a member ID other than 8 or
9. When the EX8200 Virtual Chassis configuration is not preprovisioned,
the external Routing Engine assumes a member ID that is not 8 or 9. The
EX8200 Virtual Chassis cannot be formed until this member ID
configuration is changed using this procedure.
Interconnect the member switches and external Routing Engines. See Connecting an
9.
EX8200 Switch to an XRE200 External Routing Engine and Interconnecting XRE200
External Routing Engines.
Commit the configuration:
10.
[edit]
user@external-routing-engine# commit synchronize
Power on the backup external Routing Engine, if needed.
11.
Example: Setting Up a Full Mesh EX8200 Virtual Chassis with Two EX8200 Switches
and Redundant XRE200 External Routing Engines on page 1087
Setting a 10-GigabitEthernet Port as a Virtual Chassis Port in an EX8200 Virtual Chassis
(CLI Procedure) on page 1097
Adding or Replacing a Member Switch or an External Routing Engine in an EX8200
Virtual Chassis (CLI Procedure) on page 1095
Verifying the Member ID, Role, and Neighbor Member Connections of an EX8200 Virtual
Chassis Member on page 1103
You can configure an EX8200 Virtual Chassis to include two EX8200 switches and one
or two XRE200 External Routing Engines. You can add or replace a member switch or
an external Routing Engine if one needs to be replaced for any reason.
To add or replace a member switch or external Routing Engine in an EX8200 Virtual
Chassis:
If you are replacing an existing switch or external Routing Engine, power off the device.
1.
See Powering Off an EX8200 Switch or Powering Off an XRE200 External Routing
Engine.
Uncable the device that you will remove from the Virtual Chassis.
2.
Upgrade the software on the new switch or external Routing Engine to the Junos OS
3.
release currently running in the Virtual Chassis, unless the switch or external Routing
Engine is already running that release. See "Installing Software on an EX Series Switch
with a Single Routing Engine (CLI Procedure)" on page 84 or "Installing Software on
an EX8200 Switch with Redundant Routing Engines (CLI Procedure)" on page 85.
Chapter 46: Configuring EX8200 Virtual Chassis
1095