Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1195

Configuring a VCP Link From Member Switch 0 to Member Switch 1
Step-by-Step
Procedure
Configuring a VCP Link from Member Switch 1 to Member Switch 0
Step-by-Step
Procedure
Verification
Purpose
Action
Copyright © 2010, Juniper Networks, Inc.
member 9 {
role routing-engine;
serial-number def456;
}
To configure the VCP link between the member switches, log on to the EX8208 member
switch (member ID 0):
user@external-routing-engine>
request virtual-chassis vc-port set fpc-slot 4 pic-slot 0 port 2 member 1
To configure the VCP link between the member switches, log on to the EX8216 member
switch (member ID 1):
user@external-routing-engine>
request virtual-chassis vc-port set fpc-slot 3 pic-slot 0 port 2 member 0
To verify that the Virtual Chassis is operational, perform this task:
Verifying that the Virtual Chassis is Operational on page 1091
Verifying that the Virtual Chassis is Operational
Verify that the Virtual Chassis is operational and that all VCP links in the Virtual Chassis
are functioning properly.
Enter the
show virtual-chassis status
user@external-routing-engine> show virtual-chassis status
Preprovisioned Virtual Chassis
Virtual Chassis ID: c806.0842.de51
List
Member ID Status
0 (FPC 0-15) Prsnt
1 (FPC 16-31) Prsnt
8 (FPC 128-143) Prsnt
9 (FPC 144-159) Prsnt
Chapter 45: EX8200 Virtual Chassis—Configuration Example
command:
Mastership
Serial No Model priority
ghi789 ex8208
jkl112 ex8216
abc123 ex-xre
def456 ex-xre
Neighbor
Role ID Interface
0 Linecard 8 vcp-0/0
9 vcp-0/1
1 vcp-3/0/2
0 Linecard 8 vcp-0/0
9 vcp-0/1
0 vcp-4/0/2
129 Master* 9 vcp-1/0
0 vcp-1/1
1 vcp-1/2
129 Backup 8 vcp-1/0
0 vcp-1/1
1091