Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1193

Table 165: Components of the EX8200 Virtual Chassis Topology (continued)
Interfaces
Setting the EX8200 Switches as Virtual Chassis Members
Step-by-Step
Procedure
Copyright © 2010, Juniper Networks, Inc.
The master XRE200 External Routing interfaces:
vcp-1/0
(member 9).
vcp-1/1
on the EX8208 member switch (member 0).
vcp-1/2
on the EX8216 member switch (member 1).
The backup XRE200 External Routing interfaces:
vcp-1/0
(member 8).
vcp-1/1
on the EX8208 member switch (member 0).
vcp-1/2
on the EX8216 member switch (member 1).
The EX8208 member switch interfaces
vcp-0/0
on the master external Routing Engine (member 8).
vcp-0/1
on the backup external Routing Engine (member 9).
xe-3/0/2
1).
The EX8216 member switch interfaces:
vcp-0/0
on the master external Routing Engine (member 8).
vcp-0/1
on the backup external Routing Engine (member 9).
xe-4/0/2
0).
This example assumes that all devices in the Virtual Chassis are running the same version
of Junos OS Release 10.4 or later. If you need to upgrade a device in the Virtual Chassis
configuration to meet this requirement, perform that upgrade before performing this
procedure.
To set the switches as Virtual Chassis members, perform this task:
To configure EX8200 switches as Virtual Chassis members, log onto each switch and
enter the
set chassis virtual-chassis
On the EX8208 switch:
user@switch> set chassis virtual-chassis
On the EX8216 switch:
user@switch> set chassis virtual-chassis
Chapter 45: EX8200 Virtual Chassis—Configuration Example
—Connects to vcp-1/0 on the backup external Routing Engine
—Connects to vcp-0/0 (the MGMT
—Connects to vcp-0/0 (the MGMT
—Connects to vcp-1/0 on the master external Routing Engine
—Connects to vcp-0/1 (the MGMT
—Connects to vcp-0/1 (the MGMT
(the MGMT port on the module in slot RE0)—Connects to
(the MGMT port on the module in slot RE1)—Connects to
—Connects to xe-4/0/2 on the EX8216 member switch (member
(the MGMT port on the module in slot RE0)—Connects to
(the MGMT port on the module in slot RE1)—Connects to
—Connects to xe-3/0/2 on the EX8208 member switch (member
command.
port on the module in slot RE0)
port on the module in slot RE0)
port on the module in slot RE1)
port on the module in slot RE1)
vcp-1/1
vcp-1/1
vcp-1/2
vcp-1/2
1089